82
Chapter 4
POSSIBLE PROBLEMS/SOLUTIONS
1. After the dockside cord is hooked up to
the boat and the marina dock power cen-
ter and the AC ship’s panel main breaker
for shorepower is activated no voltage is
shown on the main panel AC volt meter.
Check the breaker on the marina dock power center to
ensure it is activated.
Check the main breaker/voltage sensing device. The
“power” icon should show green.
Check the ELCI main breaker/voltage sensing device.
The power icon should show green. If a leakage fault ex-
ists a red icon will light indicating the breaker is “tripped”.
Use the test button to reset the breaker after the condi-
tion has been rectied.
Notify marina personnel to verify power and correct po-
larity at the dock distribution center.
To Next Page
Loading...
