131
Battery Charger
If installed the battery charger delivers up to 20
amps of DC current and uses a 120 AC voltage
input (extension cord/power inlet plug).
As a result of lightweight design it delivers faster
charging through optimal cooling. It utilizes fully
automatic multi-stage charging and enhances bat-
tery performance with 5 sequential stages with in-
tegrated easy to read monitor with LED bars. Sys-
tem check ok and battery status indicators result in
accurate battery status feedback.
Battery charger utilizes 2 output legs one for each
battery switch.
Lazarette Actuator Control Box
This component integrates a breaker to control
the actuator cylinders used to open and close the
Lazarette storage compartment. There are relays
inside the control box. A breaker controls the up-
ward cylinder travel and the other breaker controls
the downward cylinder travel. The control breaker
protects the relay circuit wiring.
PowerTower Actuator Control Box
This component integrates a breaker to control the
port and starboard actuator cylinders used to con-
trol the PowerTower angling forward and upright.
There are relays inside the control box. One break-
er controls the tower port actuator while a second
breaker controls the starboard actuator. A sepa-
rate breaker protects the entire relay wiring circuit.
To Next Page
Loading...
