71
The helm station may be equipped with the ability
to monitor engine functions through a single or dual
Garmin chart plotter system. Close observation of
the digital display is recommended throughout the
trip as you can split the screen to accommodate
GPS functions along with monitoring basic
engine systems including fuel usage and hours for
maintenance cycles. This works in addition to the
engine manufacturer’s information panel system.
SELECTED
OPTIONS
SHOWN
Helm Systems
Obviously with the dual chart plotter option
another whole dimension of information monitoring
is achievable. Note that with the battery switches
in the “off” position, there is no power to the helm
and the ignition switch will not function.
All electrical features are protected by the main
battery management panel located in the sump.
Refer to earlier pages in this chapter for additional
information. Note to read and understand the
blower warning/operation information on
the bottom of the breaker switch panel.
Helm Overview- (Typical)
GAS VAPOR
DETECTOR
20 AMP IGNITION
BREAKER
IGNITION
SWITCH
BREAKER PANEL
BLOWER
SWITCH
TRIM TAB
PANEL
REMOTE
CONTROL
SAFETY
LANYARD
ENGINE
INFORMATION
PANEL
TI LT
STEERING
KNOB
AUTOMATIC FIRE
EXTINGUISHER
GAUGE.
GLOVE BOX
STORAGE
GARMIN
CHART PLOTTER
DC FUSE PANEL
BEHIND HELM
ACCENT
DASH LIGHT
SWITCH
BLOWER
WARNING LABEL
To Next Page
Loading...
