194
Boat (Continued)
Note that select equipment including the
toilet system and Seakeeper stabilizer may be
installed on your vessel. These units require
additional maintenance in cold/freezing climates
including the following:
• Pump-out fresh water and waste tanks when
installed to prevent freeze damage in cold climates.
Add non-toxic anti-freeze.
• Empty chemical toilet holding tank and add non-
toxic anti-freeze.
• If installed drain Seakeeper sea water intake
system including any sea water strainers aling with
the heat exchanger unit.
Note the more typical pressurized water system
option instructions are found on this page. For
further details refer to your equipment operator’s
manual or contact your closest authorized Regal
dealer.
Trailer
• Repack all wheel bearings per manufacturer’s
specifications.
• Check all trailer parts for excessive wear. Replace/
refurbish as needed.
• Use touch up paint on trailer as needed.
• Lubricate all moving parts as needed.
• Check all lighting and brakes (if applicable).
Typical Pressurized Water System
1. Activate the pressure water pump switch.
2. Open all faucets including transom shower (if
equipped) and allow tank to empty.
3. Drain the water tank. Shut off water pump switch.
4. Mix nontoxic antifreeze with water in accordance
with the manufacturer’s recommendations. (Available
at marina & RV stores)
5. Pour solution into the water tank.
6. Turn on pressure water pump switch.
7. Open water faucet and purge until a steady
stream of nontoxic antifreeze flows from the faucet.
If equipped, do the same to the transom shower.
Turn the pressure water switch to the “off” position.
Waste System
1. With chemical heads, make sure to dump both
upper and lower tanks. Rinse well with fresh water.
Sanitize chemical head as needed.
2. Toilets with overboard discharge require
additional procedures including waste removal from
the holding tank with a pump-out device found at
select marine facility locations.
To Next Page
Loading...
