52
Engine Checklist Before Each Outing
Every engine option may require different checks
before each use, but a general outboard engine
checklist guide is included here. Read your Yamaha
outboard owner’s manual for more detailed
information regarding start-up procedures.
At Helm/Deck
• Check engine crankcase and gearcase oil
levels. If needed refer to the outboard owner’s
manual for type and quantity.
• Check power steering fluid pump levels.
• Check power trim fluid/trim tab levels at the
pump motor.
• Open the Lazarette compartment and preform
a fuel sniff and visual test for leaks. If vapors are
detected call for professional assistance. Do
not attempt to start the outboard engine!
• When all of the system checks above are
completed preform the following:
• Activate the battery switch(es)
• Start the engine and check for a steady stream
of water from the pilot hole.
• Check control lever for operational defects.
• Check the clip and safety lanyard for proper
operation.
• Check fuel level and ensure the level is sufficient
for the trip with a 1/3 reserve.
• Check all gauges for functionality including
your engine gauge panel located on the chart
plotter screen.
• Check ignition panel. Make sure the outboard
shuts down when key is turned to “off”.
To Next Page
Loading...
