97
As part of select outboards under the motor shroud
(engine cover) on the lower port side of the outboard
engine is a fuel filter. Periodically check to ensure the
fuel filter is clean and free of water. When reinstalling
the filter tighten to manufacturer’s specifications.
Check for leaks after starting the engine. For more
information refer to the outboard manufacturer’s
owners manual or contact a Regal dealer or marine
professional.
CHECKING ENGINE MOUNTED FUEL FILTER
CHECKING INLINE WATER SEPARATOR
FILTER
Inside the Lazarette
center cockpit
storage area a 10
micron in-line water
separator filter is
installed. Use an oil
spanner type wrench
and turn the filter
counterclockwise to
remove the element.
Using a clean pan
empty the filter
contents and examine the fuel. Water in fuel tends
to hug the bottom since it is heavier than fuel and
will show a different color. At least yearly or on an
as needed basis replace the filter element. Fill the
element up with fresh unleaded fuel of the correct
octane rating (assists with keeping air out of the fuel
system) and turn it clockwise by hand until tight. As
always check for leaks before starting the engine.
It makes sense to keep extra fuel filters on board in
protective wrap for emergency use.
To Next Page
Loading...
