A) Location of Components
B) Pipes, Tubing and Fittings
C) Electrical Interconnections
3.0 INSTALLATION
A) To Enter the Engineering Mode
B) Engineering Parameters
C) To Exit the Engineering Mode
5.0 ENGINEERING MODE
A) Linearizing (Calibrating) the SMARTVALVE
B) Setting Control Parameters
C) Setting the Lag Time
7.0 SYSTEM START-UP
A) Flow Proportional Control
B) Residual Only Control
C) Compound Loop Control
D) Feed Forward Dechlorination
8.0 OPERATIONAL MODE
A) Calibrating the Analog Input(s)
B) Calibrating the Analog Output
C) Setting the Mechanical Zero
9.0 MAINTENANCE
10.0 SPECIFICATIONS
A) To Enter the Configuration Mode
B) Configuration Parameters
C) To Exit the Configuration Mode
6.0 CONFIGURATION MODE
A) The Importance of Mixing
B) The Importance of Lag Times
C) The Importance of Proper Sizing of
System Components
D) Transient Voltage Surge Suppression
2.0 DESIGN AND INSTALLATION
CONSIDERATIONS
A) Flow Proportional Control
B) Residual Only Control
C) Compound Loop Control
D) Feed Forward Dechlorination
E) Chloramination
1.0 INTRODUCTION
4.0 GENERAL INFORMATION
PRIOR TO START-UP
IMPORTANT:
Fill out and mail or fax the form on the reverse side
to establish your warranty.
CONTENTS
PLACE
STAMP
HERE
CHLORINATORS INCORPORATED
1044 SE Dixie Cutoff Road
Stuart, FL 34994-3436
4
To Next Page
Loading...