33
(2) Put the oil pan into the cutouts of table
(3) put the machine casting hinge cushion into
the cutouts of table and fix it by nails .
and
fix it by nails ;
2. Installing the machine head (Fig. 3)
(1) Insert the knee lifting rod ;
(2) Insert the casting hinge to the hole in the
bed;
(3) Put the hinge in the cushion and put the
head on the pad ;
(4) Inset the machine head supporter in the table.
Notice:
Be sure to full inset the supporter in the table
Otherwise it may cause danger while put the
machine head down.
2b2b
To Next Page
Loading...
