Reloop innoFADER User Manual

INSTALL INSTRUCTIONS
Reloop Distribution
Global Distribution GmbH
Schuckertstr. 28
48153 Münster / Germany
Fax ++49/251/6099368
Subject to alterations.
Illustrations similar to original product.
Misprints excepted.
Copyright 2015
V1.5
Warning! Dismantling your mixer could invalidate the warranty. If you are
unsure of your ability to safely carry out this work then it is advised that
you leave it to a qualified service technician
Check compatible mixers on www.reloop.com/reloop-rmx-innofader
Safety instructions: Please always make sure the mixer is powered off
and the power plug is unplugged.
CAUTION!
For your own safety, please read this operation manual carefully before
initial operation! All persons involved in the installation, setting-up,
operation, maintenance and service of this device must be appropriately
qualified and observe this operation manual in detail. This product
complies with the requirements of the applicable European and national
regulations. Conformity has been proven. The respective statements
and documents are deposited at the manufacturer.
HOW TO REPLACE THE CROSSFADER:
1
Remove the fader cap and the two screws shown in the red
circle. Take off the crossfader plate carefully.
2
Remove the two screws shown in the red circle.
3
Unplug the crossfader connection cable by slightly pulling
it out of the socket connector, while holding one thumb on
the connection shaft. Please do this very carefully.
4
Remove the two screws shown in the red circle. Take off
the mounting plate.
Compatible with Reloop RMX-10/22i/33i/60/80 and all
future Reloop products with INNOFADER compatible logo
IM_RMX_innofader_V1.5_15012015.indd 1 16.07.2015 09:25:20

Reloop innoFADER Specifications

General

Brand	Reloop
Model	innoFADER
Category	Mixer
Language	English

Summary

How to Replace the Crossfader

Remove Fader Cap and Plate

Remove fader cap and screws, then carefully lift off the crossfader plate.

Remove Plate Screws

Remove the two screws located in the red circle.

Disconnect Connection Cable

Carefully unplug the crossfader connection cable from its socket.

Remove Mounting Plate

Remove the two screws securing the mounting plate and detach it.

Attach Plate to Innofader

Fix the mounting plate onto the mini Innofader using screws and connect the adapter cable.

Connect Adapter to Mixer

Plug the adapter cable into the mixer, aligning grey cables for correct connection.

Install Mini Innofader

Place the mini Innofader into the unit, tighten screws, and ensure correct orientation.

Reattach Crossfader Plate

Put the crossfader plate back on and secure it with screws, then fit the fader cap.

Final Connection and Power On

Reconnect power, turn on the mixer; the Innofader should function correctly.