Your RP-8000 is an advanced high torque turntable with an industry
rst integrated performance pad section that is capable of controlling
MIDI software.
The RP-8000 is ready for Serato DJ and works
seamlessly plug ‘n‘ play (Ofcial Serato Accessory).
This Quick Start Guide will help you to set up, connect and control
your RP-8000 with Serato DJ (version 1.6.2 or higher).
Please make sure to download the latest version of Serato DJ at:
www.serato.com
LED CHECK MODE
Cue + push trax + power on
STAND BY SEQUENCE
Loop + push trax + power on
ALL MIDI SEND ON / OFF
Sample + push trax + power on
(determines whether all elements of the
turntable should send MIDI or not)
- Push Pad 1 to select (On/Off)
- Push Trax / Nav to save setting.
DUAL MODE ON / OFF
Sample + push trax + power on
- Push Pad 2 to select (On/Off)
- Push Trax / Nav to save setting.
FIRMWARE UPDATE MODE
Slicer (user) + trax + power on
FIRMWARE SETTINGS
PLAYER 1PLAYER 3 PLAYER 2
SLAVE 1MASTERSLAVE 2 SLAVE 3
PLAYER 4
SMART USB LINK
You can smartly link up to four RP-8000 in
series by using the USB link function.
In this way one turntable is connected directly
to the computer (Master / Player 1) and each
further turntable connected is automatically
set to the next channel in a chain
(Slave / Player 2,3,4).
Hint:
To manually select a MIDI channel (deck select)
on your turntable, you can hold down the
Navigation Trax Encoder at any time down for
approx. three seconds. The display will highlight
the active channel. Turn the encoder to select a
deck 1 – 4 or hit the pads 1-4 to set a channel.
Start the rmware update program on your
computer and follow the on-screen instructions
+ +
+ + / /
+ +
+ +
+
+
To Next Page
Need help?
General
