Need help?Do you have a question about the Reloop RP8000 and is the answer not in the manual?
General| Type | Direct Drive Turntable |
|---|---|
| Drive System | Direct Drive |
| Platter | Die-cast aluminum |
| Platter Diameter | 332 mm |
| Tonearm Length | 230 mm |
| Tonearm Overhang | 15 mm |
| USB Output | Yes |
| USB Recording | Yes |
| Power Supply | AC 100-240V, 50/60Hz |
| Cartridge | Not included |
| Motor | Brushless DC Motor |
| Turntable Speed | 33 1/3, 45 RPM |
| Wow and Flutter | 0.1% WRMS |
| S/N Ratio | > 55dB (DIN-B) |
| Tonearm Type | S-shaped Tonearm |
| Connections | RCA, USB |
| Digital Output | USB |
| Start-up Time | Less than 1 second |
| Pitch Range | +/-8 %, +/-16 %, +/-50 % |
| Outputs | RCA, USB |
| USB | USB |
Illustrates DVS setup with mixers/interfaces and outlines connection requirements for multiple units.
Covers firmware updates, driver installation, VirtualDJ 8 installation, and licensing for controller use.
Details setting up audio configurations and MIDI operation within VirtualDJ for the RP-8000.
Explains the primary controls like START/STOP, SPEED selection, REVERSE, and power ON/OFF.
Details controls for PITCH, QUARTZLOCK, PITCH RANGE, and TORQUE/START/BRAKE SPEED.
Describes how the LCD displays Pitch and BPM values and how to toggle between modes.
Guides on assigning the RP-8000 to specific MIDI channels (1-4) for controlling VirtualDJ decks.
Explains how to set and trigger Hot Cue points using the turntable's performance pads.
Details triggering loops, loop rolls, and adjusting loop parameters using the performance pads.
Describes how to trigger samples, select banks, and adjust sample playback modes.
Explains how to use the Slicer mode for beat-mashing and creating rhythmic slices.
Covers combined HotCue/Loop, HotCue/Sampler, and Loop/Sampler modes for advanced performance.
Details the function of each rear panel connection, including AUDIO OUTPUT, USB, and TT LINK.
To Next Page
