What to do if my REMEHA iSense Pro DIN AD280 Thermostat displays 'FL.DRY.B XX DAYS'?
The message 'FL.DRY.B XX DAYS' indicates that floor drying is in progress. During this time, heating to unaffected circuits is disabled. Allow the indicated number of days to count down to 0. Afterward, set the 'SCREED DRYING' parameter to 'OFF'.
What to do if the floor drying is active on my REMEHA Thermostat?
If the floor drying function is active, you can either wait for the displayed number of days to reach 0, or you can manually turn off the SCREED DRYING parameter.
General| Brand | REMEHA |
|---|---|
| Model | iSense Pro DIN AD280 |
| Category | Thermostat |
| Language | English |
Explains danger levels and symbols used in the manual for user safety.
Lists common abbreviations used in the manual.
Provides general information and manufacturer/installer liability details.
Lists compliance with European directives and standards.
Provides safety recommendations and warnings for installation and operation.
Details the function of each button on the control panel.
Explains the various symbols and indicators shown on the display.
Lists electrical supply and sensor resistance data.
Lists all items included in the product package.
Guidance on selecting location and connecting the outside sensor.
Instructions for mounting and connecting the module to various boiler types.
Covers recommendations, terminal blocks, BUS cable, heating circuits, DHW, etc.
Provides a visual schematic of the appliance's electrical wiring.
Steps for initial setup and powering on the appliance.
How to access different user, installer, and service levels.
Guide to navigating and interacting with the appliance's menu system.
How to view measured values and parameters in the #MEASURES menu.
How to switch to the extended parameter display mode.
Guide to configuring installation-specific parameters.
How to assign custom names to circuits and generators.
How to adjust the heating curve parameters for optimal performance.
How to change the display language of the appliance.
How to set the appliance's configuration mode.
Steps to calibrate connected sensors for accurate readings.
Advanced settings and parameter adjustments for installers.
How to set up network communication and cascade configurations.
Procedure to reset the appliance to its original factory configuration.
Procedure for safely shutting down the appliance during installation.
How antifreeze protection works and how to activate it.
How to display installer contact information in case of errors.
Lists and explains common error messages and their solutions.
How to view a history of past messages and errors.
Details specific fault codes, their descriptions, and troubleshooting steps.
Procedure to remove sensor data from the appliance's memory.
How to consult failure history and perform parameter/I/O checks.
General advice on using original spare parts and warranty procedures.
Lists and illustrates available spare parts with their corresponding codes.
To Next Page
