Why does my Remington 100089-06A Chainsaw saw leak oil?
It is normal for oil to seep when the Remington chainsaw is not in use. To minimize this, tighten the oil cap and empty the oil tank when the saw is not in use.
What to do if my Remington 100089-06A motor doesn't run when I squeeze the trigger?
If the motor of your Remington chainsaw doesn't run when you squeeze the trigger, consider these potential causes: 1. Ensure the switch lockout is fully pushed forward to release the trigger. 2. Check for loose connections in the extension cord. 3. Inspect the line fuse or circuit breaker.
What to do if my Remington Chainsaw chain does not get oil?
If the chain on your Remington chainsaw isn't getting oil, the possible causes are: 1. The oil slot in the guide bar is clogged. Remove the guide bar and clean the oil slot. 2. The oil is too thick. Use the correct weight of oil.
What to do if my Remington 100089-06A chain comes off the guide bar?
If the chain keeps coming off the guide bar of your Remington chainsaw: 1. The chain may be too loose. Tighten the chain. 2. The guide bar and chain might not be assembled correctly.
What to do if my Remington 100089-06A motor runs, but the chain does not move?
If the motor of your Remington chainsaw runs but the chain doesn't move, the gear sprocket may be damaged. Remove and inspect the gear sprocket.
Why does my Remington Chainsaw run slow and stall easily?
If your Remington chainsaw runs slowly and stalls easily, the low power supply voltage might be the issue. The extension cord wire size may be too small.
What to do if my Remington 100089-06A Chainsaw leaks oil?
It's normal for some oil to seep out when the Remington chainsaw is not in use. Try tightening the oil cap. When the chainsaw is not in use, empty the oil tank.
What to do if the motor of my Remington 100089-06A does not run when I squeeze the trigger?
Push the switch lockout forward before squeezing the trigger. Check the cord connections. Check the line fuse or circuit breaker.
To Next Page
General