7
CLEANING AND MAINTENANCE
To ensure long lasting performance of your epilator, clean the head assembly regularly.
Cleaning the epilation head after each use:
• Ensure the epilator is turned o and disconnected from the mains.
• Press the head release button and open the head assembly (Figure F).
• Turn the head assembly upside down.
• The epilator head can be removed and rinsed for cleaning. For optimal cleaning;
brush hairs from the tweezers before rinsing (Figure G).
• Although the epilator is suitable for use under running water, it is not
recommended to submerge the unit under water.
NOTE: Do not completely submerge in water. The epilator head can be submerged after
it has been removed from the epilator body.
TO REMOVE RESIDUE:
• To remove residue from the stainless steel tweezers, dampen a swab with alcohol.
• Gently run the swab over the tweezers until the residue has been removed.
• CAUTION: Make sure that the cotton swab is not soaked in alcohol as this may
damage the epilator.
CLEANING THE SHAVER HEAD AFTER EACH USE:
• Ensure the epilator is turned o and disconnected from the mains.
• Press the head release button and remove the shaving head.
• Remove the blade and trimmer assembly by placing your ngers either side of the
assembly and pulling upwards.
• Gently shake the blade and trimmer assembly to remove the hair. Use the cleaning
brush to brush the trimmers and shaver housing.
• Replace the blade and trimmer assembly.
NOTE: Never use the cleaning brush on the foil as damage may occur.
RECYCLING
W
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate ocial recycling/
collection point.
To Next Page
Loading...
