Remington G2 Graphite Series - Care and Maintenance; After Each Use; Battery Removal

8
3-Day Stubble, and Body Hair Maintenance; 30mm Trimmer Head With
1.5mm or 3mm Fixed Comb
Let your stubble grow to a length that is slightly longer than the look you
are trying to achieve.
1. Fit the 1.5 mm fixed comb to the wide trimmer attachment.
2. Run your trimmer through your beard against the direction of hair
growth.
• For more control over the length of your stubble, you can use the
adjustable comb and trim your stubble down in increments starting at
a longer length setting until you get the desired look.
Beard / Moustache: 30mm Trimmer Head With Adjustable Comb
(2-20mm)
1. Use a small comb to straighten hairs for trimming.
2. Fit the 30mm trimmer head and adjustable comb.
3. Set the adjustable comb to the desired length.
4. Start trimming under the chin following the line of the jaw.
5. Work upwards towards the ear and upper beard line.
Contour Edging: 30mm Trimmer Head
1. Hold the groomer with the cutting blade (teeth) facing you and at 90
degrees to the skin.
2. Start with the edge of the beard/moustache line and, with the blade
resting lightly against the skin, use slow controlled movements to
create contoured lines.
Close Hair Cutting: 30mm Trimmer Head
1. Use the fingers of one hand to lift the hair at the base of your head up
off your neck.
2. Your index finger should be covering the roots of the hairs you are
lifting to prevent them from being accidentally cut.
3. Hold the groomer to the base of your neck with the blade facing up.
Move the groomer up the neck until it touches your index finger which
is protecting the hair roots.
4. Move your groomer slowly and keep the hair roots at the base of your
head out of the way of the groomer.