Remington HC5355 - Deep Cleaning and Lubrication; Cleaning Cautions and Storage; BATTERY REMOVAL; Battery Removal and Disposal

8
, Note: Ensure the clipper is turned o when cleaning.
• Suitable for cleaning under an open water tap.
, EVERY SIX MONTHS
• At regular intervals the blade set should be removed and cleaned.
• Removethe2screwsretainingthexedbladewithascrewdriver.Donot
remove blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not
remove the lubricating grease from the blades. It is not necessary to remove
the small moving blade from the unit.
• Ifthemovingbladehasbeenremovedthiscanbere-ttedbyslottingthe
blade holder over the pin in the centre of the interior product head. The
groove on the blade, just below the teeth, rests on a metal plate at the
 oppositesidetothescrewholes.Thexedbladeisttedwiththeraised
 prolepointingoutwardsandxedwiththe2screws.
• Ifthebladesarenotcorrectlyaligned,cuttingeciencywillbeimpaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe o
excess oil.
, CAUTION:
• Do not use liquid cleaners on the blades or harsh or corrosive chemicals on
the blade casing. Always use a soft brush to remove the accumulated hairs.
• Unplugthechargeadaptorfromthepoweroutletwhenttingorremoving
attachments, or while cleaning the product.
• Alwaysstorethisapplianceandcordinamoisture-freearea.
• Do not wrap the cord of the charging adaptor around the appliance.
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Ensure that the clipper is discharged of all power and disconnected from the
mains.
• Lift or pry the USB port cover plate on the bottom of the clipper.
• Lift or pry the deco plate on the lower portion of the clipper and unscrew 1
screw located on the back housing of the clipper.
• Lift or pry the clipper halves apart, exposing the battery chamber.
• Lift or pry the USB connector and lift or pry the cover plate on the bottom of
the battery chamber.