9
C CARE FOR YOUR TRIMMER
• Care for your appliance to ensure a long lasting performance.
• The easiest and most hygienic way to clean the appliance is by rinsing the
appliance head after use with warm water.
• Keep the switch in the “o” position when not in use.
, AFTER EACH USE
• Rinse the accumulated hair from the cutters and shake of excess water.
• To clean the unit, wipe with a damp cloth and dry immediately.
• This product is suitable for use in the shower and for cleaning under water.
, CLEANING
• Only the attachment guide combs and trimmer blade may be removed
from the product for cleaning.
• Cleaning should be done with a soft brush.
• Suitable for cleaning under an open water tap.
• Do not use harsh or corrosive cleaners on the units or their cutters.
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when
removing the battery.
• Ensure that the clipper is discharged of all power and disconnected from
the mains
• Lift or pry the USB port cover plate on the bottom of the clipper.
• Lift or pry the deco plate on the lower portion of the clipper and unscrew 1
screw located on the back housing of the clipper.
• Lift or pry the clipper halves apart, exposing the battery chamber.
• Lift or pry the USB connector and lift or pry the cover plate on the bottom
of the battery chamber.
• Remove the battery and printed circuit board assembly from the battery
chamber.
• Cut the tabs on both ends of the battery and remove it from the printed
circuit board.
• The battery is to be disposed of safely.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSL
AE HR
UA
To Next Page
Loading...
