Remington HC5356 - Hair Clipper Care and Maintenance; Routine Cleaning and Six-Month Servicing

8
• To ensure long lasting performance of your clipper, clean the blades and
unit regularly.
• Always keep the attachment guide comb on the trimmer blade.
, AFTER EACH USE
• Ensure the appliance is switched o and unplugged from the mains before
cleaning.
• Brush the accumulated hair from the blades. Do not submerge the clipper in
water.
• To clean the unit, wipe with a damp cloth and dry immediately.
, WASHABLE CLEANING
• The QUICK WASH SYSTEM is designed to maximise the eciency of
washable cleaning.
• Click the buttons located on the sides of the hair clipper head; the blades
will slide out and the blade set can be easily cleaned under the tap.
• Once the blades are cleaned the blades are locked into place by pushing the
blade set towards the hair clipper head and will snap into place.
• Do not run the entire unit under the tap, only the blade set is meant to be
submerged in water.
• Suitable for cleaning under an open water tap.
, Note: Ensure the clipper is turned o when cleaning.
, EVERY SIX MONTHS
• At regular intervals the blade set should be removed and cleaned.
• Remove the 2 screws retaining the xed blade with a screwdriver. Do not
remove blade set.
• Brush out hairs from between the blades with soft cleaning brush. Do not
remove the lubricating grease from the blades. It is not necessary to remove
the small moving blade from the unit.
• If the moving blade has been removed this can be re-tted by slotting the
blade holder over the pin in the centre of the interior product head. The
groove on the blade, just below the teeth, rests on a metal plate at the
opposite side to the screw holes. The xed blade is tted with the raised
prole pointing outwards and xed with the 2 screws.
• If the blades are not correctly aligned, cutting eciency will be impaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe o
excess oil.
ENGLISH