7
, SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
• Starting with the longest guide comb attached (24-42mm), cut from the
back of the neck to the crown. Hold the guide comb at against the head
and slowly move the clipper through the hair.
• Use the same procedure from the lower side to the upper side of the head.
Then cut the hair against the direction in which it grows and level with the
sides.
• To give a “at top” look, the hair on top of the head must be cut over the
top of a at comb.
• Use a closer guide comb to taper the hair down to the neckline as desired.
, HAIR TEXTURE MECHANISM
• Simply adjust the hair texture mechanism by sliding the button at the top
of the hair clipper.
• Blending dierent length areas. Select the proper length guard to blend.
Slide out the hair texture mechanism (guard) which allows you to blend /
thin out the area.
• Textured cut – Slide out the hair texture mechanism (guard) to give an all
over textured cut.
, TRIMMER
• To turn on, twist the battery cover to the right.
, TO DEFINE THE BEARD/MOUSTACHE LINE
• Hold the trimmer with the trimmer blade facing you.
• Start with edge of beard/moustache line and gently lower the trimmer
blade onto your skin. Use motions towards edge of beard/moustache line
to trim to desired locations in facial area and away from beard in neck area.
, TRIMMING EDGE OF SIDEBURNS
• Hold the trimmer with the trimmer blade facing you.
• Start with edge of sideburn, and with the trimmer blades resting lightly
against your skin, use motions towards edge of sideburn line to trim the
desired locations in facial area.
• To switch o, twist the battery cover to the left aligning the body of the
trimmer.
C CARE FOR YOUR HAIRCLIPPER
• Your clipper is tted with high quality blades.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSL
AE HR
UA
To Next Page
Loading...
