6
, TO REMOVE THE COMB
• Press and hold the release button and holding the clipper with the blades
facing away from you, rmly push the comb upward and away from the
blades.
• Each comb attachment is marked accordingly on its outside middle surface
(3-21 mm & 24-42 mm).
, INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through
the hair. Do not force it through quickly. If you are cutting for the rst time,
start with the maximum comb attachment.
, STEP 1 – Nape of the neck
• Set the comb to 3mm or 6mm.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at
the centre of the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair,
trimming just a little at a time.
, STEP 2 – Back of the head
• With the comb set at 12mm or 18mm, cut the hair at the back of the head.
, STEP 3 – Side of the head
• Set the comb to 3mm or 6mm, trim sideburns. Then change the setting to
9mm and continue to cut the top of the head.
, STEP 4 – Top of the head
• Use the longer length comb attachment and set it to 24mm or 27mm then
cut hair on top of the head against the direction in which the hair normally
grows.
• For longer hair on top, use the longer length comb attachment (24 – 42mm)
to achieve the desired style.
• Always work from the back of the head.
, STEP 5 – The nishing touches
• Use the clipper without an attachment comb for close trimming around the
base and sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper.
• Place the reversed clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
ENGLISH
To Next Page
Loading...
