5
, SHORT LENGTH SELECTION DIAL (Fig. 6)
• The short length adjustment dial can be adjusted to give you 5 different
cutting lengths (0.8 - 2mm) simply by turning the wheel to the desired
setting. Turn the wheel anti-clockwise for longer length and clockwise for
shorter length.
, INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through
the hair. Do not force it through quickly. If you are cutting for the first time,
start with the maximum comb attachment.
, STEP 1 – Nape of the neck (Fig. 1)
• Use 3mm or 6mm guide comb.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at
the centre of the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair,
trimming just a little at a time.
, STEP 2 – Back of the head (Fig. 2)
• With the comb set at 9mm or 12mm, cut the hair at the back of the head.
, STEP 3 – Side of the head (Fig. 3)
• With the 9mm or 12mm guide comb attached, trim sideburns. Then change
to the longer 20mm guide comb and continue to cut the top of the head.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSI
AE HR
UA
3
2
1
4
6
5
To Next Page
Loading...
