Remington HC5810 - HAIRCLIPPER CARE AND MAINTENANCE; Finishing and Styling; Cleaning and Servicing

6
, STEP 4 – Top of the head (Fig. 4)
• Attach the 25-40mm guide comb, cut hair on top of the head against the
direction in which the hair normally grows.
• For longer hair on top, use without a guide comb. Lift the hair on top of the
head with a small hand comb. Cut over the hand comb with the hair lifted or
hold the hair between the fingers to lift it and cut it to the desired length.
, STEP 5 – The finishing touches (Fig. 5)
• Use the clipper without an attachment comb for close trimming around the
base and sides of the neck.
C CARE FOR YOUR HAIRCLIPPER
• Your clipper is fitted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit
regularly.
• Always keep the attachment guide comb on the trimmer blade.
, AFTER EACH USE
• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Brush the accumulated hair from the blades and body of the clipper. Do not
submerge the clipper in water.
• To clean the unit, wipe with a damp cloth and dry immediately.
, Note: Ensure the clipper is turned off when cleaning.
, EVERY SIX MONTHS
• Ensure the appliance is switched off and unplugged from the mains.
• Hold the clipper in one hand so that the blades are at the top, place your
thumb underneath the blades and press upwards, the blade set will detach
from the clipper.
• Brush the accumulated hair from the blades.
• Replace the blade set by inserting the hook into the bottom of the hair
pocket and pushing down until you hear an audible ‘click’.
• If the blades are not correctly aligned, cutting efficiency will be impaired.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off
excess oil.
, CLEANING CAUTIONS
• Ensure the appliance is switched off and unplugged from the mains.
ENGLISH