4
C GETTING STARTED
Before using your hairclipper for the first time, charge for 14-16 hours.
Connect the charging adaptor to the charging stand / product and then to the
mains. Place the hairclipper into the stand. The LED fuel gauge will light up.
, LED FUEL GAUGE
• When the clipper is fully charged, all green LED lights will be on.
• Use the product until the battery is low. This is indicated by illuminated red
fuel gauge.
• When the clipper is charging the green LED lights will flash.
• Your clipper cannot be overcharged. However, if the product is not going to
be used for an extended period of time (2-3 months), unplug it from the
mains and store.
• Fully recharge your hairclipper when you would like to use it again.
• To preserve the life of your batteries, let them run out every 6 months then
recharge for 14-16 hours.
, CORDED USE
• For corded use connect the product to the adaptor, then to the mains.
, CAUTION
• Extended mains only use will result in the reduction of the battery life.
F INSTRUCTIONS FOR USE
, BEFORE STARTING THE CUT
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
• Each guide comb is marked accordingly on its outside surface (3mm, 6mm,
9mm, 12mm, 16mm, 20mm, 25mm, 30mm, 35mm, 40mm).
, TO ATTACH A COMB
• Slide it onto and along the clipper blade until the front of the comb firmly sits
against the clipper blade.
, TO REMOVE THE COMB
• Holding the clipper with the blades facing away from you, firmly push the
comb upward and away from the blades.
ENGLISH
To Next Page
Loading...
