4
PARTS
1. On/o switch
2. Blade set
3. Short length selection dial
4. LED fuel gauge
5. 10 attachment guide combs
6. Charging stand
Not shown:
• Charging adaptor
• Storage case
• Hairdressing cape
GETTING STARTED
Before using your hairclipper for the rst time, charge for 14-16 hours.
Connect the charging adaptor to the charging stand / product and then to the mains. Place
the hairclipper into the stand. The LED fuel gauge will light up.
LED FUEL GAUGE
• When the clipper is fully charged, all green LED lights will be on.
• Use the product until the battery is low. This is indicated by illuminated red fuel gauge.
• When the clipper is charging the green LED lights will ash.
• Your clipper cannot be overcharged. However, if the product is not going to be used for
an extended period of time (2-3 months), unplug it from the mains and store.
• Fully recharge your hairclipper when you would like to use it again.
• To preserve the life of your batteries, let them run out every 6 months then recharge for
14-16 hours.
CORDED USE
For corded use connect the product to the adaptor, then to the mains.
CAUTION
Extended mains only use will result in the reduction of the battery life.
INSTRUCTIONS FOR USE
BEFORE STARTING THE CUT
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
• Each guide comb is marked accordingly on its outside surface (3mm, 6mm, 9mm, 12mm,
16mm, 20mm, 25mm, 30mm, 35mm, 40mm).
TO ATTACH A COMB
• Slide it onto and along the clipper blade until the front of the comb rmly sits against
the clipper blade.
ENGLISH
To Next Page
Loading...
