EasyManua.ls Logo

Remington HC6550 - Step 4 - Top of the Head; Step 5 - The Finishing Touches; Short Tapered Styles; Care and Maintenance

Remington HC6550
160 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
, STEP 4 – Top of the head
With the 18mm or 22mm guide comb attached, cut hair on top of the head
against the direction in which the hair normally grows.
, Note: For longer desired lengths of more than 22mm, place nger over hair
and guide into the guide comb and blade to better guide the hairs
trimmings into the vacuum chamber.
Always work from the back of the head.
, STEP 5 – The nishing touches
• Usetheclipperwithoutaguidecombforclosetrimmingaroundthebase
and sides of the neck.
• Toproduceacleanstraightlineatthesideburns,reversethehairclipper.
• Placethereversedclipperatrightanglestothehead,tipsoftheblades
lightly touching the skin and then work downwards.
, SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
• Startingwiththelongestguidecombattached(25mm),cutfromtheback
of the neck to the crown. Hold the guide comb at against the head and
slowly
move the clipper through the hair.
• Usethesameprocedurefromthelowersidetotheuppersideofthehead.
• Thencutthehairagainstthedirectioninwhichitgrowsandlevelwiththe
sides.
• Togivea“attop”look,thehairontopoftheheadmustbecutoverthetop
of a at comb.
• Useacloserguidecombtotaperthehairdowntothenecklineasdesired.
C CARE FOR YOUR HAIRCLIPPER
• Toensurelonglastingperformanceoftheclipper,cleanthebladesandunit
regularly.
• Ensuretheapplianceisswitchedoandunpluggedfromthemainsoutlet
before cleaning
• Donotuseharshorcorrosivecleanersontheunitsortheircutters.
• Cleaningshouldbedonewithasoftbrush.
, AFTER EACH USE
• Brushtheaccumulatedhairfromtheblades.
• Tocleantheunit,wipewithadampclothanddryimmediately.
, Note: To maintain the eective vacuum performance of the clipper,
regularly brush or rinse ne hairs in the mesh panel found at the base of the
vacuum chamber.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSI
AE HR
UA

Other manuals for Remington HC6550

Related product manuals