ENGLISH
3
080694_REM_IFU_PG410_22L.indd 3080694_REM_IFU_PG410_22L.indd 3 05.11.2008 13:56:08 Uhr05.11.2008 13:56:08 Uhr
ATTACHING AND REMOVING THE HEADS
To attach or remove the heads press the red release button at both sides of the product.
TO THIN AND TAPER THE BEARD/MOUSTACHE (DIAGRAM 1)
Attach a guide comb to the 3 mm Trimmer Blade. If you are trimming for the first time
start with the maximum trimming length setting.
Turn the unit on.
Place the flat top of the trimmer comb against the skin.
Slowly slide the personal groomer through the hair. Repeat from different directions as
necessary.
If hair builds up in the trimmer comb during the trimming process, switch the unit off, pull
off the comb and brush/rinse off.
TRIMMING EDGE OF SIDEBURNS (DIAGRAM 2)
Hold the personal groomer with 3 mm Trimmer Blade facing you.
Start with edge of sideburn, and with the trimmer blades resting lightly against your skin,
use motions towards edge of sideburn line to trim to desired locations in facial area.
8
8
USING THE SHAVER (DIAGRAM 3)
Attach the shaver.
Use short, well-controlled movements. Use your free hand to stretch your skin. This
encourages the hair to stand upright, making it easier to shave.
NOTE: Always trim your facial hair first before shaving.
Tips for best results
Beard, moustache and sideburn hairs should be dry.
Avoid using lotions before using your personal groomer.
To Next Page
Loading...
