6
Fuel Gauge
Charge Level
Fuel Gauge Lights
During Charging During Use
Charging
Lights will cycle in an
upwards pattern
-
Fully Charged
All lights will remain lit
for 5 minutes and then
switch off
Lights will cycle in
an upwards and
downwards pattern
Battery charge is low
(3 minutes or less run
time available)
- Bottom light will flash
• In addition, the fuel gauge shows the level of charge for 5 seconds
after the unit has been switched off after use.
Lights Remaining Charge Level
Bottom light will flash Battery charge low
Bottom light on 33%
Bottom and middle light on 33 - 66%
All lights on 66 - 100%
• Run time from fully charged is up to 60 minutes.
• Unplug the charger when the unit is fully charged .
• To preserve the life of your batteries, let them run out every 6 months
then recharge for 4 hours.
ATTACHMENTS
Ensure that the device is switched off before fitting or removing
attachments.
To Fit and Remove Blades
• To remove, pull the blade upwards out of the body of the device.
• To fit, position the blade as desired then insert it into the opening and
press it downwards until it clicks into place.
• The T-blade and micro detail blade can be positioned facing upwards
or downwards to help you trim difficult to reach areas.
To Next Page
Loading...
