4
GETTING STARTED
CHARGING YOUR APPLIANCE
• It is recommended to fully charge your appliance before using it for the first time.
• Ensure the product is switched off.
• Connect the product to the USB cable and then to the USB end of the cable to a
powered USB port.
• Run time from fully charged is up to 60 mins.
• Charge time from empty is 120 minutes.
• Note: To preserve the life of your batteries, let them run out every 6 months then fully
charge.
QUICK CHARGE
• Quick charge feature: Your shaver is fitted with a 5 minute quick charge feature that
will provide enough charge for 1 shave (3 minutes).
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to four weeks to allow time
for your beard and skin to become accustomed to the new shaving system.
SHAVING
1. Switch the shaver on by pressing the On/Off button.
2. Stretch the skin with your free hand so the hairs stand upright.
3. Hold the shaving head so that the foils touch your face.
4. Use short, linear strokes.
SHAVING WITH SHAVING GEL
• Follow the same instructions as dry shaving if using shaving gel.
• CAUTION After use with shaving gel, please rinse the head and cutters under warm
water to clean away any excess gel and debris.
TRIMMING
1. Push the trimmer release button up to activate the trimmer.
2. Hold the trimmer at right angles to your skin.
3. To retract the trimmer, slide the trimmer release button down and push the back of
the trimmer head downwards until it locks into place.
STUBBLE LOOK
• Fit the stubble head guard to your shaver for a 3-day stubble look.
To Next Page
Loading...
