Remington PG180 - Using Your Grooming Kit; Attaching and Removing the Comb; Preparation Before Use; Beard and Moustache Styling

4
3. Insert 2 “AA” alkaline batteries, so that the (+) and (-) marks on the battery face the
same mark in the battery compartment.
4. Replace the battery compartment cover.
Note: Remove batteries if the unit is not in use for long periods.
INSTRUCTIONS FOR USE
ATTACHING AND REMOVING THE COMB
• The adjustable guide comb gives 5 dierent trim lengths.
• To fasten the guide comb, snap on to the back of the detail trimmer head.
• If you are trimming for the rst time start with the maximum trimming length
setting.
BEFORE YOU BEGIN
• Comb facial hair with a ne comb before you start trimming.
• Hairs should be dry and without any waxes or lotions before using the groomer.
TO THIN AND TAPER BEARDS OR MOUSTACHES
1. Attach the trimmer blade.
2. Place the hair length attachment on the trimmer blade, select the desired length
and switch on.
3. Start trimming under the chin, following the jawbone line.
4. Work towards the ear and upper beard line using an upward motion.
TO TRIM EDGE OF BEARD OR MOUSTACHE
1. Attach the trimmer blade.
2. Hold groomer with cutting blade facing you.
3. Start with edge of beard/moustache line, and with the cutting blades resting lightly
against your skin, use slow movements to create a beard/moustache line.
TO TRIM SIDEBURNS
1. Attach the trimmer blade.
2. Use a small comb to lift the hairs. Hold the comb at the desired beard or moustache
length.
3. Move the groomer along the comb to cut the hairs. Use light pressure and
well-controlled movements to trim hair.
TRIMMING THE NAPE OF YOUR NECK
1. Attach the trimmer blade.
2. Use your ngers to lift the hair at the base of your head up o the neck.
3. Your index nger should be covering the roots of the hairs you are lifting to prevent
accidental removal by groomer.