6
Step 2: Back of the head
• With the comb set at 12mm or 18mm, cut the hair at the back of the head.
Step 3: Side of the head
1. Adjust the comb to a shorter length setting for the areas around the ears.
2. Increase the length setting on the adjustable comb to gradually transition the length
of hair on the side of the head to the longer hair on the top of the head.
Step 4: Top of the head
1. Adjust the comb to the longer length settings (up to 20 mm) then cut the hair on top of
the head against the direction in which the hair normally grows.
2. Always work from the back of the head.
Trim the sideburns
• To trim the sideburns, adjust the comb to the desired length setting, or use one of the
xed guide combs.
SHORT/LONG BEARD TRIMMING
Attachments
Wide trimmer with adjustable comb
Precision trimmer
1. Fit the wide trimmer and adjustable comb.
2. Set the adjustable comb to the desired length.
3. Start trimming under the chin following the line of the jaw.
4. Work upwards towards the ear and upper beard line.
5. Tidy the beard edges using the precision trimmer attachment.
CONTOUR EDGING AND CLOSE HAIR CUTTING
Attachments
Wide trimmer
Contour edging:
1. Hold the device with the cutting blade (teeth) facing you and at 90 degrees to the skin.
2. Start with the edge of the beard/moustache line and, with the blade resting lightly
against the skin, use slow controlled movements to create contoured lines.
Close hair cutting:
1. Use the ngers of one hand to lift the hair at the base of your head up o your neck.
2. Your index nger should be covering the roots of the hairs you are lifting to prevent
them from being accidentally cut.
3. Hold the trimmer to the base of your neck with the blade facing up. Move the trimmer
up the neck until it touches your index nger which is protecting the hair roots.
4. Move your trimmer slowly and keep the hair roots at the base of your head out of the
way of the trimmer.
ENGLISH
To Next Page
Loading...
