Remington PG3000 - Product Setup and Charging; Component Identification; Charging Your Appliance; Attaching and Removing Accessories

4
PARTS
1. On/O switch
2. Charging indicator light
3. Charging connector
4. Wide trimmer
5. Adjustable comb
6. Attachment guide combs
7. Detail trimmer
8. Nose, ear, eyebrow trimmer
9. Adaptor (not shown)
10. Storage pouch (not shown)
CHARGING YOUR APPLIANCE
Before using your trimmer for the rst time, charge for 16 hours.
1. Ensure the product is switched o.
2. Connect the charging adaptor to the product and then to the mains.
• When charging, the charge indicator light will light up.
• Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 16 hours.
• On a full charge, your beard trimmer will run for up to 40 minutes of cordless usage.
ACCESSORIES
TO FIT AND REMOVE ATTACHMENTS FIG. A
Ensure that the device is switched o before tting or removing attachments.
• To remove, rotate the attachment anti-clockwise until it unlocks and then lift it o.
• To t, place the desired attachment on top of the device and rotate the attachment
clockwise to lock it into place.
FITTING AND REMOVING FIXED GUIDE COMBS
To Fit
• Hook the front of the guide comb over the teeth of the wide trimmer.
• Press the back of the guide comb down until it clicks into place.
To Remove
• Lift the tab on the back of the guide comb upwards until it comes free from the wide
trimmer head.
FITTING AND REMOVING THE ADJUSTABLE COMB
• To t, line up the rails on the comb with the slots on the sides of the groomer and
slide the comb downwards onto the groomer.
• To adjust, press and hold the adjustment button on the back of the comb and slide
the comb up or down. Release the button to lock the comb at that position. The
length of cut is indicated by the scale on the side of the trimmer.