EasyManua.ls Logo

Remington PG6000 - Charging Your Appliance; Charging Procedure; Charging Indicator Light; Attachments and Fittings

Remington PG6000
184 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
PARTS
1. On/O switch
2. Charging indicator light
3. Charging connector
4. Wide trimmer
5. Adjustable comb
6. Attachment guide combs
7. Precision trimmer
8. Nose, ear, eyebrow trimmer
9. Mini foil shaver
10. Deep cleansing brush head
11. Body hair attachment
12. Body hair attachment comb
Not shown
Adaptor
Storage pouch
CHARGING YOUR APPLIANCE
Before using your trimmer for the rst time, charge for 4 hours.
1. Ensure the product is switched o.
2. Connect the charging adaptor to the product and then to the mains.
CHARGING INDICATOR
Charge Level Light
Charging Blue LED will ash
Fully Charged Blue LED will light up continuously
Battery charge is low Red LED will ash
Run time from fully charged is up to 90 minutes.
Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store.
To preserve the life of your batteries, let them run out every 6 months then recharge
for 4 hours.
ATTACHMENTS
TO FIT AND REMOVE ATTACHMENTS (FIG. A)
Ensure that the device is switched o before tting or removing attachments.
To remove, rotate the attachment anti-clockwise until it unlocks and then lift it o.
To t, place the desired attachment on top of the device and rotate the attachment
clockwise to lock it into place.
FITTING AND REMOVING FIXED GUIDE COMBS
To Fit
Hook the front of the guide comb over the teeth of the wide trimmer.
Press the back of the guide comb down until it clicks into place.
ENGLISH

Table of Contents

Other manuals for Remington PG6000

Related product manuals