9
• Be sure to move the unit slowly when performing this operation and
to keep the hair roots at the base of your head out of the way of the
trimmer.
CLEANING ATTACHMENTS WITH WATER
Always clean the grooming system attachments regularly to ensure
maximum performance and a proper operating life.
Cleaning attachments with water
NOTE: The full size trimmer attachment is permanently lubricated, so
can be cleaned with the brush provided. If you do rinse this attachment
with cool or warm water (never use hot water) then it will need to be
re-lubricated using the light-grade oil supplied or sewing machine oil.
• Remove attachment.
• Rinse ONLY the attachment under warm running water. Do NOT use
hot water as this might cause damage.
NOTE: Blades must be lubricated again with oil if rinsed under water.
Cleaning attachments with the cleaning brush
• After removing attachment, thoroughly brush and blowout hair clippings
from cutting system, attachment, and top of groomer handle. (Do NOT
use the cleaning brush on the Foil compartment of the Foil shaver
attachment).
Cleaning the foil shaver attachment
• Remove attachment.
• Remove foil head by pressing the button on the front of the foil shaver
attachment.
• Gently tap the foil head to remove excess clippings (never use a brush
on the foil).
• Brush hair clippings from the cutter.
• Replace foil head onto the shaver attachment by gently snapping
into place.
Oiling blades & cautions
• Rinsing attachments under water (above) requires re-lubricating the
cutting blades once a month.
Using only light-grade oils (sewing machine oil can also be used),
simply spread 1-2 drops lightly over cutters with fingertip. Wipe away
all excess oil.
To Next Page
Loading...
