HOW TO USE
Before Starting to Cut
1. Inspect the hair clipper making sure it is free from hair and dirt.
2. Ensure that the hair is thoroughly dry and tangle free.
3. The blades on your hair clipper should be oiled before every haircut.
Lubricating the Hair Clipper Blades
Simply place a few drops of oil on the teeth of the blades. Use only the light
grade oil supplied or a suitable alternative like sewing machine oil. Only
this type of oil is suitable for the blades on your Remington hair clipper. Do
not use hair oil, grease or any oil mixed with kerosene or any solvent as the
solvent will evaporate and leave a thick oil, slowing the blades.
If oil is not applied to the blades or only a small amount of oil is applied,
this may cause cutting problems. Blades will wear prematurely and not cut
properly if they are not sufficiently lubricated. There may also be a pulling
sensation on the hair.
Instructions for Hair Cutting
Note: For even cutting, allow the trimmer comb/blade to cut its way through
the hair. Do not force it through quickly. If you are cutting for the first time,
start with the maximum length trimmer comb, until you know how short
you would like your hair to be.
Note: The comb guide lengths described for use in the steps below are an
example only, if you want a longer or shorter hair cut you will need to adjust
the comb guide lengths to suit your requirements.
To Attach a Comb
• Hold the comb with its teeth upward.
• To attach a comb, align the legs of the comb with the holes in the
top of the clipper on each side of the blade and slide the legs into the
trimmer until they click.
• To remove, firmly pull the comb straight up away from the clipper.
6
To Next Page
Loading...
