Remington QuickCut Pro - HAIRCUTTING INSTRUCTIONS; COMB ATTACHMENT AND REMOVAL; CUTTING STEPS: NAPE AND BACK

5
4 (Grade 1) 3 mm
5 4.5 mm
6 (Grade 2 6 mm
7 (Grade 3) 9 mm
8 (Grade 4) 12 mm
9 (Grade 5) 15 mm
10 (Grade 6) 18 mm
11 (Grade 7) 21 mm
12 (Grade 8) 25 mm
• Use the clipper without any xed combs for trimming hair close to the skin.
• This will trim hair to 1mm, holding the clipper so the blades are perpendicular to the skin will trim hair
to 0.5mm.
TO ATTACH A COMB
• Hook the front edge of the comb to the front teeth of the wide trimmer blade. Then push the back of
the comb down until it snaps in place.
TO REMOVE THE COMB
• Push up the back of the comb until it clicks o the clipper blade.
INSTRUCTIONS FOR CUTTING HAIR
• The QuickCut Clipper’s ergonomic design provides many dierent ways of holding the clipper in use.
• For clipping the top of the head (see g. 1).
• For clipping the back of the head (see g. 2).
• For clipping the sides of the head (see g. 3).
• For detailing (see g. 4).
• For even cutting, allow the comb attachment/blade to cut its way through the hair. Do not force it
through quickly. If you are cutting for the rst time, start with the maximum comb attachment.
• For one all over cut length, attach the desired guide comb and slowly guide the clipper through the
hair against the direction the hair normally grows.
• Remove the guide comb. To produce a clean straight line at the sideburns and the base of the neck,
reverse the hair clipper. Place the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
The following instructions are for those users who want dierent trimming lengths on the sides, back and
top of the head
STEP 1  NAPE OF THE NECK
• Set the comb to 3mm or 6mm.
• Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the head at the
base of the neck.
• Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little at a time.
STEP 2  BACK OF THE HEAD
• With the comb set at 9mm or 12mm, cut the hair at the back of the head.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
NO
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
SR
BG
AE