EasyManua.ls Logo

Remington QuickCut Pro - PARTS AND GETTING STARTED; APPLIANCE CHARGING; OPERATING THE CLIPPER

Remington QuickCut Pro
140 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
PARTS
1. On/o/turbo switch
2. Blade set
3. 9 attachment guide combs
4. Charger connector
5. Charging indicator
Not shown:
Cleaning brush
Oil bottle
Adaptor
Travel pouch
GETTING STARTED
CHARGING YOUR APPLIANCE
Note: It is recommended to fully charge your appliance before using for the rst time. Please refer to the
charge times shown in this book.
Connect the product to the adaptor and then to the mains.
When charging the charge indicator will slowly ash.
CHARGE LEVEL INDICATORS
Charge Level Indicator
Charging LED blinks
Fully charged LED solid
Run time from fully charged is up to 70 minutes.
Charge time from empty is 4 hours.
Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.
QUICK CHARGE FUNCTION
5 minutes charging will give an emergency burst of run time.
INSTRUCTIONS FOR USE
For corded use connect the product to the adaptor, then to the mains.
CAUTION Extended mains only use will result in the reduction of the battery life.
CORDLESS USE
When the unit is switched on and fully charged, the product can be used in cordless mode for up to 70
minutes.
Switch the product on by pressing the on/o switch.
BEFORE STARTING THE CUT
Inspect the clipper making sure that it is free from hair and dirt.
Before cutting, always comb the hair so it is tangle free and dry.
Guide Comb Cutting length
1 (Grade 0) 1.5 mm
2 2 mm
3 2.5 mm
ENGLISH

Table of Contents

Related product manuals