6
TO REPLACE THE FOIL/CUTTERS
• Remove the shaver head (pull the head up and off).
• Fit the new head assembly over the hair pocket and press down to click into place.
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
1. Pry off the two decorative side panels.
2. Unscrew one screw from the bottom of the shaver and remove the bottom panel.
3. Remove the foil assembly and unscrew the 4 screws underneath it.
4. Remove the two E-rings one on each side of the head then lift off the upper head
assembly.
5. Unscrew the 2 screws below the upper head assembly then lift the rest of the head
off the body.
6. Pry off the upper decorative panel to expose 2 screws. Remove the screws.
7. Remove the front panel to expose 4 screws. Remove the 4 screws then remove the
back housing.
8. Lift out the battery and printed circuit board assembly.
9. Disconnect the battery from the circuit board.
• Dispose of the battery safely.
ADAPTER SPECIFICATIONS
Manufacturer address and
registration number
Spectrum Brands (UK) Limited, Regent Mill, Fir Street,
Failsworth, Manchester M35 0HS
Company number: 02394603
Adapter model number PA-0505K
Input voltage 100 - 240 V~
Input AC Frequency 50/60Hz
Output voltage
5.0 V
D
Output current 0.5 A
Output power 2.5 W
Average active efficiency ≥73.16%
Efficiency at 10% -
No load power consumption ≤0.1W
To Next Page
Loading...
