Remocon RMC-600 - User Manual

To Next Page

Instruction Manual for Self-learning

model RMC-600 & Y2K10L

RMC-600 Y2K10L

Note: If the existing remote is code hopping you will not be able to clone it

successfully.

1). Setting the frequency (Using our adjusted bar).

a. Make sure jumper 2 is installed and place 2 remotes(existing remote and

REMOCON remote) within 1 cm of each other. Press any button of both

remotes and hold until the LED of REMOCON remote flashes 3 times.

b. Still hold the buttons and increase the distance of both remotes to about 3

cm apart and observe the brightness of LED of REMOCON remote. Adjust the

frequency until the LED show maximum brightness.

c. If you can't find a suitable adjustment, change the jumper 1 to the next

position and repeat from step a.

Need help?

Do you have a question about the Remocon RMC-600 and is the answer not in the manual?

Summary

Adjust the remote's frequency using the adjuster bar and jumpers for optimal signal reception.

Copy buttons from an existing remote to the new one by aligning them and pressing keys.

Remove and reposition jumper 2 after cloning to prevent loss and ensure future use.

Perform programming in areas free from electrical interference for correct operation.

General