Rev. 02 – July 16
th
, 2009
7 Normal Procedures
Normal Procedures 7 - 5
If the engine does not start, release the key to position "0", wait 2
minutes and repeat
the procedure.
5. Release ignition key, immediately after the engine has
started
6. Push the choke lever forward
7. Switch of the electric fuel pump (if fitted)
Starting a hot engine:
1. Pull the throttle lever back to idle position
2. Turn the key clockwise to the “Start“ position and hold until
the engine has started. Do not hold the key in that position
for more than 10 seconds, in order to avoid overheating the
starter.
3. Release ignition key, immediately after the engine has
started
After starting the engine:
1. Check oil pressure immediately after the engine has started
2. Adjust engine rpm as required - for warm up max. 2.500 rpm
3. Before take-off, oil and CHT temperature must reach 120°F
at least
4. Switch on avionics master switch and all required avionics
devices
Engine rpm and propeller check:
1. Set parking brake
2. Adjust engine to 4.000 rpm
3. Check both magnetos – maximum rpm decrease 300 rpm
4. Set engine to idle
7.4 Taxiing
The steerable nosewheel of the REMOS GX allows easy ground
handling. Turns of 49 feet in diameter can be conducted easily. The
main gear is equipped with hydraulic disc brakes, which are operated
by a lever on top of the middle section between the seats.
To Next Page
Loading...
