Remote Control SOMFY KEYGO T4 PRO

To Next Page

Programming Manual

http://www.remotecontrol-express.com - TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151

SOMFY KEYGO T4 PRO

Programming with the receiver:

receiver type 1 (fig 1) :

1. Open the receiver cover. It is located in the vicinity of the motor.

2. Press on the receiver board the programming button "Prog 1" (fig 1) until the LED L1 on the

receiver lights.

3. Press a button on the new remote. Release the button. The LED on the receiver flashes and

then goes out.

4. Wait for 10 seconds.

5. Your new remote control is now programmed.

receiver type 2 (fig 2) :

Fig 2

1. Open the receiver cover. It is located in the vicinity of the motor.

2. Press one of the arrow buttons on the receiver until the position F0 appears on the display.

Need help?

Do you have a question about the Remote Control SOMFY KEYGO T4 PRO and is the answer not in the manual?

Remote Control SOMFY KEYGO T4 PRO Specifications

General

Instructions for programming the remote with receiver type 1, involving a programming button and LED indicator on the receiver board.

Steps for programming the remote with receiver type 2, utilizing receiver display codes, arrow buttons, and validation sequences.