Renault CAPTUR - Exterior Lighting and Signals

lighting:
exterior ............................................(up to the end of the DU)
lights:
side lights .........................................................(current page)
signals and lights ..................................(up to the end of the DU)
lighting:
instrument panel ..............................................(current page)
lights:
main beam headlights ......................................(current page)
lights:
dipped beam headlights ...................................(current page)
1.61
ENG_UD28989_1
Éclairages et signalisations extérieures (X87 - Renault)ENG_NU_1007-1_X87_Renault_1
Daytime running lights
function
(front lights only)
Depending on the vehicle, daytime run-
ning lights come on automatically when
the engine is started.
Exterior lighting and signals
EXTERIOR LIGHTING AND SIGNALS (1/3)
š
Side lights
Turn the ring 2 until the symbol
is opposite mark 3.
An indicator light on the instrument
panel will come on.
1
Before driving at night, check that the electrical equipment is operating
correctly and adjust the headlight beams (if your vehicle is not carrying
its normal load). As a general precaution, check that the lights are not ob-
scured (by dirt, mud, snow or objects being transported).
k
Dipped beam
headlights
Manual operation
Turn the ring 2 until the symbol is oppo-
site mark 3. This indicator light on the
instrument panel comes on.
Automatic operation
(depending on vehicle)
Turn ring 2 until the AUTO symbol is op-
posite mark 3: with the engine running,
the dipped beam headlights switch on
or off automatically depending on the
brightness of the light outside, without
any action on stalk 1.
When driving on the left in a left-
hand drive vehicle (or vice versa),
drivers must re-adjust their lights
throughout their stay (see “Adjusting
headlight beams” in Section 1).
3
1 2