Need help?Do you have a question about the Renault MR18 F3R 2021 and is the answer not in the manual?
Defines the components included and excluded from the engine area for FIA regulations.
Displays the engine's power output in relation to RPM.
Illustrates the engine's torque output across different RPM ranges.
Details the specific wooden box used for engine transportation.
Specifies the types of seals provided with new or rebuilt engines.
Explains how to locate the engine number on the ELB plat.
Introduces Wintax and Sysma software for data download and ECU calibration.
Guides on opening and using the SYSMA software for engine parameter adjustment.
Describes selecting tire suppliers (Hankook, Michelin, Pirelli) within SYSMA.
Mentions Wintax user manual and channel information availability.
Identifies the Magneti Marelli SRG140 as the engine management unit.
Explains the ELB device for recording strategic engine life information.
Details required IP address and firewall settings for ECU communication.
Advises checking Vref supply for sensor issues and potential voltage drops.
Lists diagnostic codes, their significations, and ignition limiter active states.
Specifies approved oil type and filter replacement procedures.
Emphasizes careful routing of wiring looms to prevent damage.
Outlines checks for looms, connectors, and power connections post-event.
Provides a diagram and list of engine wiring connectors and their functions.
Lists key sensors installed on the chassis that require status checks.
Advises careful handling and thread greasing for lambda sensors.
Instructs on the correct orientation when installing the barometric sensor.
Details air filter importance, cleaning, and prohibited treatments like oil for foam filters.
Specifies recommended intervals for air filter checks and cleaning.
Lists essential checks including fluid levels and sensor verification before engine start.
Guides through the process of calibrating pedal and throttle sensor inputs.
Details steps for warming up the engine safely, including oil pressure and temperature checks.
Advises on maintaining correct fluid levels and preventing airbox contamination.
Defines acceptable ranges for coolant and oil temperatures and pressures.
Explains the engine speed limiter settings and activation conditions.
Provides a chart recommending maintenance tasks at different intervals.
Step-by-step guide for cleaning the Green High Performance Air Filter.
Details the process and specifications for replacing spark plugs.
Outlines the steps and part number for oil filter replacement.
Refers to Sachs instructions and torque specifications for clutch nuts.
Specifies torque values and grease application for flywheel screws.
To Next Page
General
