Renault Scenic 2002 - Gear Lever; Handbrake; Power Assisted Steering; To Select Reverse

2
1
QXBIUDB*T[G3DJH
MEGANE SCENIC M ONOSPACE NU 679-3
C:\Documentum\Checkout\nu679-3_eng_T2.WIN 25/9/2002 11:24
-page6
2.06
GEAR LEVER HANDBRAKE POWER STEERING
To select reverse
(vehicle stationary)
Move the lever to neutral, then
position the lever in reverse.
Ring 1 has to be lifted up to the gear
lever knob to select reverse gear.
The reversing lights will come on as
soon as reverse gear is selected
(ignition on).
To release:
Pull the lever up slightly, press
button 2 and then lower the lever to
the floor.
The red warning light on the
instrument panel will come on if
you are driving with the handbrake
not correctly released.
To apply:
Pull the lever up.
The lever should travel about
10 notches to hold the car. Your
vehicle is fitted with self-adjusting
rear brake shoes and the handbrake
should only be adjusted during a
brake overhaul.
When the car is
stationary, apply the
handbrake fully to
ensure that the car
cannot move unintentionally.
Make sure the handbrake is
properly released when driving,
otherwise overheating may
occur.
When power assisted steering is
fitted, never leave the steering
wheel on full lock when the vehicle
is parked as this may damage the
pump.
Never switch off the
ignition when travelling
downhill, and avoid
doing so when driving in
general (power steering and
brake servo will not function).