Renkforce T21 - 13 Maintenance and Cleaning; A) Cleaning; B) Replacing the Fuse

29
13. Maintenance and cleaning
Alwaysobservethefollowingsafetyinformationbeforecleaningorservicingtheamplier:
Live components may be exposed when the case is opened or components are removed.
The device must be disconnected from all power supplies before carrying out any servicing or repair work.
Capacitors inside the device may still carry a voltage when they have been disconnected from the power
supply.
 Repairworkmustonlybedonebyqualiedtechnicianswhoarefamiliarwiththepotentialhazardsandthe
relevant regulations.
a) Cleaning
Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these could damage the
housing or even impair the functioning of the product.
• Always disconnect the product from the power supply before cleaning it.
• Use a dry, lint-free cloth to clean the product.
b) Replacing the fuse
Ifyouneedtoreplacethefuse,onlyusefusesofthespeciedtypeandratedcurrent(see“Technicaldata”fordetails).
Never attempt to bridge or repair the fuse holder.
• Unplug the mains plug from the mains socket and disconnect the mains cable from the power-in socket (13).
• Carefully remove the fuse holder and the defective fuse from the power-in socket (13) using a suitable screwdriver.
• Removethedefectivefuseandreplaceitwithanewfuseofthespeciedtype.
• Carefully push the fuse holder with the new fuse back into its position in the power-in socket (13).
• Once you have installed the new fuse, reconnect the device to the mains.