Troubleshooting
The
product
does
not work
The
massage
intensity
is too high
or too low
No heating
or
insufficient
heating
The touch
panel is
not
working
properly
1.Disconnected power or loose
plug causing poor contact.
2.The power switch is off or
the timer has been reset.
3.The motor auto shuts-off
due to the device being on
too long activating overheating
protection.
1.Your foot is positioned at
the wrong angle.
2.Didn't choose intensity
lev
or you.
The heat function is
manufactured according
ety
standards, which limits how
fast the product can heat up.
Therefore, the heating-up
may seem a bit slow, 7-10
minutes before you can
feel the obvious heat.
1.The plastic film on the touch
panel is not removed.
2.Fingers are wet.
3.Insufficient touch area.
1.Re-plug to the
power source.
2.T
he power
switch on again.
3.Use the massager
after the motor
cools off naturally.
1.Adjust the contact angle to
get the moderate intensity.
2.The massage has 3 intensity
levels, choose the mode you
prefer. We recommend low
mode to begin with.
If you press the foot cover
to see the light, the heating
. The rate
of heating is related to
environment. If you are in a
cold area, the heating time
may take longer.
1.Remove the plastic film
before use.
y your fingers before
touching the button.
3.Use your thumb to press
buttons to get better
touch sensitivity.
08
EN DE FR IT ES
To Next Page
