Reolink Argus PT User Manual

Reolink Wireless Battery-powered Camera
11
Method 2: Directly connect the camera with the USB adapter via a USB cable and
plug it into the electrical outlet for charging & working.
Method 3: Charge the camera with Reolink Solar Panel (needs to be purchased
separately).
Note:
There is only one battery with each camera, but you can purchase more
at reolink.com or Reolink Amazon official stores.
There is a status LED under the micro USB port of the battery, which indicates the
battery charging status.
Set up the Camera on the App
Please follow the steps below to do initial setup for the battery-powered cameras
via Reolink App.
Step 1. Power on the camera and wait for it starting up. After hearing a startup
sound, you will hear repeated Ding sounds or "Please run Reolink App, add the
camera and set it up", which means you can scan the UID and start the setup
process.
Green LED
Fully charged
Orange LED
Charging

Reolink Argus PT Specifications

General

Type	IP security camera
Antenna type	External
Remote viewing	Yes
Antennas quantity	1
Placement supported	Indoor
Connectivity technology	Wireless
Bluetooth	No
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	64 GB
Sensor type	CMOS
Digital zoom	6 x
Total megapixels	- MP
Maximum resolution	- pixels
Supported video modes	1080p
Video compression formats	H.264
Cables included	Micro-USB
Pan range	0 - 355 °
Tilt angle range	0 - 140 °
Minimum illumination	- lx
Night vision distance	10 m
Security algorithms	WEP, WPA-PSK, WPA2-PSK
Alert notification type	E-mail
Motion sensor technology	Passive infrared (PIR) sensor
DC output current	2 A
DC output voltage	5
Power source type	Battery, DC
Operating temperature (T-T)	-10 - 55 °C
Form factor	Dome
Mounting type	Ceiling/wall
Product color	White
International Protection (IP) code	IP65

Weight and Dimensions

Height	112 mm
Weight	470 g
Diameter	98 mm