Install the Camera
Installation Tips
• Do not face the camera towards any light sources.
• Do not point the camera towards a glass window. Or, it may result in
poor image performance because of the window glare by infrared LEDs,
ambient lights or status lights.
• Do not place the camera in a shaded area and point it towards a well-lit
area. Or, it may result in poor image performance. For better image
quality, please make sure that the lighting condition for both the camera
and the capture object is the same.
• For better image quality, it’s recommended to clean the lens with a soft
cloth from time to time.
• Make sure the power ports are not exposed to water or moisture or
blocked by dirt or other elements.
• Do not install the camera at places where rain and snow may hit the
lens directly.
• The camera may work in extreme cold conditions as low as -25°C.
Because when it is powered on, the camera will produce heat. You may
power on the camera indoors for a few minutes before installing it
outdoors.
8English
7 English
Drill holes in accordance with the
mounting hole template.
NOTE: Use the drywall anchors
included in the package if needed.
NOTE: Run the cable through the
cable notch on the mount base.
Install the mount base with the
mounting screws included in
the package.
Mount the Camera
NOTE: There are two dierent types of mounts for bullet cameras.
Please check out the mount included in the package and follow the
corresponding instruction to install the camera properly.
1
2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
