Reolink RLC-843A - Set Up the Camera; On Smartphone Setup; On PC Setup

English English9 10
Adjust the camera’s viewing
angle as needed.
Attach the dome cover to the
camera base by tightening the
screws.
4
5
Troubleshooting
• Make sure your camera is powered on properly. The PoE camera should
be powered by a PoE switch/injector, a Reolink NVR or a 12V power
adapter.
• If the camera is connected to a PoE device as listed above, connect it to
another PoE port and check again.
• Try again with another Ethernet cable.
If your camera is not powering on, please try the following solutions:
Camera is not Powering on
If the picture from the camera is not clear, please try the following
solutions:
• Check the camera dome cover for dirt, dust or spiderwebs, and clean
the dome cover with a soft, clean cloth. The dust-absorber included in the
package is recommended.
•Pointthecameratoawell-litarea,thelightingconditionwillaectthe
picture quality a lot.
•Upgradethermwareofyourcameratothelatestversion.
• Restore the camera to factory settings and check out again.
Picture is not Clear