What to do if REPLIGEN KrosFlo TFF Scales display 'LH' during switching on?
If your REPLIGEN Scales show 'LH' when you turn it on, it means the weighing pan was loaded during the startup. To fix this, simply unload the weighing pan. The display should then show a zero indication.
Why do REPLIGEN KrosFlo TFF Scales switch off automatically?
Your REPLIGEN Scales might be automatically shutting down because the parameter is set to a value that enforces shutdown after a specific time. To resolve this, go to the 'Othr' menu and set the parameter to 'nonE'.
Essential safety guidelines for handling the scale and its components.
Steps for assembling the scale, including foot installation and pan placement.
Guidance on how to operate the scale, covering the keypad, operational panel, and menu navigation.
Rules for ensuring long-term operation and accurate mass measurement.
Procedure for zeroing the scale indication with an empty weighing pan.
How to tare the scale, including manual entry and memory usage.
Setting the start and temporary units for measurements.
Process for calibrating the scale using an external calibration weight.
Guide for user-initiated calibration with a specified weight.
Information on the automatically generated calibration report.
Adjusting the filter settings to stabilize measurements.
Adjusting the stabilization rate for measurement results.
Setting parameters related to environmental conditions affecting the scale.
Enabling or disabling the automatic control of zero indication.
Entering, storing, and selecting tare values from memory.
Function to disable the display of the last weighing indication digit.
Configuring settings for the RS232 communication port.
Usage of USB Type A and B ports for data transfer and connection.
Settings for connecting and communicating with a computer via ports.
Options for selecting the port to connect a printer.
Configuring the connection for an additional display unit.
Defining which variables are included in the calibration report.
Selecting variables for Good Laboratory Practice (GLP) weighing printouts.
Adjusting the display brightness level.
Enabling or disabling audible feedback for key presses.
Setting an automatic shutdown time interval for the device.
Setting the current date, time, and their display formats.
Restoring the scale to its default operator settings.
Accessing informative parameters like serial number and program version.
Overview of the scale's available working modes.
How to select and start different working modes on the scale.
Customizing specific functions within each working mode.
Enabling or disabling access to specific working modes.
Configuring how data is saved or sent to a peripheral device.
Setting the frequency for automatic printouts.
Configuring the lower threshold for automatic operation.
Specific settings for the Weighing working mode.
Specific settings for the Parts Counting working mode.
Methods to determine or enter the mass of a single sample piece.
Specific settings for the +/- control working mode.
Setting minimum and maximum thresholds for check weighing.
Specific settings for the Percent Weighing working mode.
Methods to determine or enter the reference sample mass.
How to use the Peak Hold function to capture maximum force.
Specific settings for the Totalizing working mode.
How to sum and print the total mass of weighed ingredients.
Specific settings for the Animal Weighing working mode.
How to perform weighing operations for animals.
Procedures for cleaning different components of the scale.
Instructions for cleaning ABS plastic parts of the scale.
Guidelines for cleaning stainless steel parts.
How to clean aluminum components safely.
Detailed dimensions of the auxiliary scale unit.
Overview of the scale's connector ports and their arrangement.
Common problems and their suggested solutions.
List of error codes and their meanings.
To Next Page
General
