Operation Instruction
11
Operation Instruction
12
Before using your RESCOMF Ventilation Disinfector XD100
please ensure that;
Visible residue in the CPAP/BiPAP mask/nasal pillow is wiped
clean using a cleansing wipe or damp cloth.
Accessories to be sanitized are disconnected/removed from
the CPAP/BiPAP machine.
For better disinfection results it is recommended that you put your
CPAP/BiPAP accessories and RESCOMF Ventilation Disinfector
inside an airtight container, the dimension of this container size
is smaller or equal to 350x220x140mm(13.78” x 8.66” x 5.57” ) .
Operating your RESCOMF Ventilation
Disinfector is simple;
To turn on, press and hold the On/Off button for 3 seconds.The
buzzer will beep once, the light will turn green and ozone will start
streaming.
Ozone will stream for 30 minutes. then the device will circulate
fresh air for 5 minutes.The last 5 minutes of fresh air will remove
most of the residual ozone.The smell of Ozone may be unpleasant
to some users.
After the 35 minute cycle has been completed, the machine will
automatically power off. You will hear 5 beeps when this happens.
The green light will also turn off when the cycle has finished.
Please do not use your CPAP/Bi-Level accessories for at least an
hour after the cycle has finished.
If for any reason you would like to manually turn off the power during
the sanitization process, just press and hold the On/Off button for 3
seconds. The machine will sound off with a long beep indicating the
machine is powering off and the green light will then turn off as well.
On/Off button
To Next Page
Loading...